• 0
    • Free Overnight Shipping for $1499!
    • Shopping Cart is Empty

1. Manual clean boot

  • Press and hold the power button and select suspend to hang.
  • Remove the battery from the back of the terminal.
  • Use the stylus to press the Reset button located on the left side of the battery compartment.
  • Reinsert the battery and immediately press and hold the power button and the volume down button (right lower button).
  • Press and hold the power button and the volume down button until you follow the on-screen instructions and prompt "Release Buttons".
  • Press the volume up button on the right to accept the clean boot.
  • Waiting for the terminal to load the file……


2. SmartSystem control
Right click on the Intermec 70 Series terminal and select Intermec Power Tools > Clean Boot Device.

3. Clean boot barcode
Clean Boot can be achieved by scanning the clean boot 2D barcode below.
Clean boot 2d barcode
4. Special manual Clean Boot

  • When the Intermec 70 Series terminal is in blue screen, it cannot be started.
  • Place the device on an external power source that does not require a battery.
  • Use the stylus to press the Reset button located on the left side of the battery compartment.
  • Press and hold the power button and volume down button (lower right button) immediately.
  • Press and hold the power button and the volume down button until you follow the on-screen instructions and prompt "Release Buttons".
  • Press the volume up button on the right to accept Clean Boot.
  • Waiting for the terminal to load the file……